banner

TREX Products
TREX Rail Lighting

TREX® Rail Lighting Installation Guidelines


Page 3
Timer Operation Instructions

Select the mode of operation
>> Dusk to Dawn
>> 1 - 8 hours
>> Always "ON"
>> "OFF"

Program repeats daily. When power is flowing to lights, green light above POWER is on.

Installing Post Cap Lights
NOTE:
Install post cap lights after the railing system, post sleeve skirt, and post sleeve have been installed.

TREX Rail

  1. Connect male lead from wiring to female connector from cap. Also attach male-to-male connection wires in between each splitter. Continue until all wiring from lights are attached to splitters as well as connector wires are attached in between splitters. (See Making Connections for details).
  2. After verifying wiring is correct by turning lights on, attach cap to top of post with silicone caulk.

Installing Deck Rail Lights
NOTE:
Instruction shown below are for new deck installation and are shown BEFORE railing system has been installed.
TREX Rail

  1. Place post sleeve over pressure-treated post and mark desired height, centered on post sleeve for deck rail light location.

    NOTE: If deck boards are not installed yet, place an appropriate deck width spacer board to ensure post sleeve is at correct height.
    TREX Rail

  2. Drill a 1" hole through post sleeve. Use care to stop drill before cutting into post.
  3. Remove the post sleeve from the post and fish wire from deck rail light through hole and down to female connector on splitter. Continue until all wiring from lights are attached to splitters as well as connector wires are attached in between splitters. (See Making Connections for details).

    IMPORTANT NOTE: Before attaching deck rail light to the post/post sleeve, make sure decking has been installed along with skirt over the post sleeve.

    TREX Rail

  4. Replace post sleeve over pressure-treated post and align holes for screws vertically and attach fixture base to post with provided screws as indicated above.
  5. Line up polycarbonate lens with fixture housing. Twist onto fixture base.

NOTE: If railing has already been installed, lead wires will need to be fished through the post sleeve to reach the desired location for the deck rail light. In some cases if the provided lead wire does not fit (due to connector size), the wire connectors can be cut off and wire nuts can be used. Test lights with the power on and if lights do not function that are wired in this method, switch the connector wires.

 

Page 1

Page 2

Page 4


TREX Transcend
Transcend Rail available in many colors

Other Trex Products:

Enhance Decking

Select Decking

Transcend Porch Flooring

Trex Rail Lighting

Trex LED Post Lights

Trex LED Rail Lights

Trex LED Riser Lights

Trex LED In-Deck Lights

 
Trex LV Transformers

Trex Remote Dimmer

Trex 6-Way Splitter

Trex Wire Packages

Trex Female Adaptor

 

Fox Home Page
Receive a copy of our
current advertising flyer by mail!
QUESTIONS? Email Us
TREX Recessed Light TREX Splitter TREX Splitter TREX Splitter TREX Splitter TREX Riser Light TREX Splitter TREX Splitter TREX Splitter TREX Splitter TREX Splitter TREX Post Light TREX Splitter TREX Splitter
image